Operation And Functions; Cleaning And Maintenance - TaoTronics DUO FREE + series Handbuch

2. Pair them with your device when the working indicator on the left earbud
flashes blue and red alternately while that on the right earbud flashes blue
slowly indicating the earbuds are in pairing mode now.
3. If you have paired your device with the earbuds before, remove "TaoTronics
Duo Free +" from the Bluetooth device list and pair again.
Note:
• Press the Multifunction Touch Control immediately when the working
indicator on the left earbud flashes blue and red alternately, or you will fail
to clear pairing history.
• If you want to pair the earbuds with another device when you have already
paired them with a device, deactivate the Bluetooth function on the paired
device or clear "TaoTronics Duo Free +" from its Bluetooth list. Restore the
earbuds to factory settings as instructed above if pairing failed.

OPERATION AND FUNCTIONS

Function Operation
Tap the Touch Control on
Play / Pause
either of the earbuds twice
Tap the Touch Control on the
Volume +
right earbud
Tap the Touch Control on the
Volume -
left earbud
Tap the Touch Control on the
Next Track
right earbud three times
Tap the Touch Control on the
Previous Track
left earbud three times
Answer Phone Tap the Touch Control on
Call either of the earbuds once
Hang up Tap the Touch Control on
Phone Call either of the earbuds twice
Tap and hold the Touch
Decline an
Control on either of the
Incoming Call
earbuds for 2 seconds
Tap the Touch Control on
Redial either of the earbuds four
times
06
Voice Prompt
/
Toots when highest setting
is reached
Toots when lowest setting
is reached
/
/
Ring tone sounds when call
is incoming
Toot when Connected
Toot
Toot
/
When paired successfully,
press and hold the Touch
Turn On / Off
Control on either of the
Voice Control
earbuds for 2 seconds until a
beep is heard.
Clear Pairing Refer to the "Clear Pairing
List List" section
Go into Pairing
Refer to the "Pairing" section
Mode
Successfully
/
paired with
your device
Bluetooth out
of Range /
Failed to pair
/
with your
device
Note: Only when you are wearing the earbuds can you hear the voice prompt.

CLEANING AND MAINTENANCE

1. Clean the earbuds and the charging case on a regular basis.
2. Use dry and soft cotton cloth to wipe the unit.
Note: Do not insert anything into the product.
3. Keep away from sharp objects to avoid scratches.
4. Put the unit in a dry and shady place if it is to be idle for a long time.
5. Do not clean the product with detergent or chemicals.
Toot
/
Pairing
Pairing Successful
Connected
Disconnected
07