Loading Aborted
4.1.19.
This error appears only on machines equipped with an automatic loading elbow. An error
o
ccurred that caused the loading syste
Discharge Aborted
4.1.20.
T
his er r appears only on machines e
ro
occurred that caused the discharge sy
Invalid Formula
4.1.21.
Th
e
use
r entered a
Load Eye Blocked
4.1.22.
This error appears only on machines equ
Up Lock Not Made
4.1.23.
This error appears only on
ca
n not e sure that the elbow is up and
b
Invalid Work Order
4.1.24.
Th
e use entered a value for this field
r
I
nval
id
Goods Code
4.1.25.
Th
e use entered a value for this field t t does not exist in the Mildata co puter.
r
Invalid Customer Code
4.1.26.
Th
e use
r entered a value for this f
I nva id Employee Code
l
4.1.27.
Th
e use entered a value for this field t t
r
C
an'
t F
ind Data
4.1.28.
Mildata machines only. Th
compu r.
te
Accumulator was Reset
4.1.29.
This e
r
ror does
not occur on MilTouch X models. The microprocessor detect
co
mpl
e
te
d-formula ac
BICLUT01 (Published) Book specs- Dates: 20151112 / 20151112 / 20151112 Lang: ENG01 Applic: CLJ
4.2. Inputs and Outputs for the MilTouch
Use the information in this document to diagnose and communicate about the machine with a
qualified technician.
Notice 3 : The data in this document applies specifically to the Milnor MilTouch
m to stop.
quipped w
stem to stop.
value for this field t t does not exist in the Mildata co puter.
ha
ipped with an automatic loading elbow.
machines eq ipped with an automatic loading elbow. The controller
u
locked in a safe position.
tha
t does not exist in the Mildata computer.
ha
ield t at does not exist in the Mildata co p
h
ha does not exist i th
e formula r uested
eq
-E
cumulator data was corrupt. All accumulators must be reset to zero.
— End of BICLUT03 —
41
ith an automatic loading elbow. An error
n e M
ild
ata co p
by th
e machine was not fo nd on the Mildata
™
Controller
PELLERIN MILNOR CORPORATION
Chapter 4. Troubleshooting
m
m
m uter.
m uter.
u
ed that the
™
input-