Milnor MilTouch Betriebshandbuch Seite 41

4
Chapter
Troubleshooting
BICLUT03 (Published) Book specs- Dates: 20151112 / 20151112 / 20151112 Lang: ENG01 Applic: CLJ
™
4.1. MilTouch and MilTouch-EX
Door Opened
4.1.1.
The Door Opened: Close the door. Press the Start button to resume operation at the current step
Electrical Failure: If the door is not open, turn the machi
to find the cause of the error.
The controller stops the wash program and turns off all outputs. Correct the error con
the Signal Cancel button, then press the Start button to resume the wash program.
Vibration Switch Tripped
4.1.2.
The Machine is not Anchored: Check the bolts that hold the machine to the floor. Tighten or
replace bolts that are loose or broken. Press the Start button to resume operation at the current
step.
The Load is Distributed Poorly: Do a check that there
extract step to allow the goods to spread around the basket. Press the Start button to resume
operation at the current step.
The Load is too Small: This machine works best when you fill it to the rated capacity of the
machine. Wash goods in full loads. Press the Start button to resume operation at the current step.
Too Long to Fill
4.1.3.
Fill Time Configured too Short: Do a check of the configured fill time. Increase the fill time if
necessary.
Low Water Pressure: Do a check of the water pressure and volume to the machine.
Water Valve Malfunctioned: Use the schematic to do a check of the water valves and the
circuits that control the valves.
The controller closes all water valves and turns off all chemical injections. When you touch the
Signal Cancel button, the controller resets the Fill Error timer and resumes the wash program.
™
Error Messages
ne Off. Do a check with the schematic
is enough water in the bath before the
37
Chapter 4. Troubleshooting
.
dition, touch
PELLERIN MILNOR CORPORATION