T Emperature Unit - Milnor MilTouch Betriebshandbuch

Chapter 1. How to Use the MilTouch
f or how you will use it, temperature and water units, etc.
T ype
—Select the type of machine shown on the machine name plate. The name plate is on
1.1.1.2.
1.1.
back side of the machine.
N ame
—Set a machine name to describe the machine on printed reports.
1.1.1.2.
1.2.
Laundry Type
1.1.1.2.
1.3.
t he 10 default formulas available without program
provides default form
L anguage
—Set a language for the
1.1.1.2.
1.4.
Water Unit
—Set whether bath height will be displayed and programmed in inches or
1.1.1.2.
1.5.
c entimeters.
Water Offset
1.1.1.2.
1.6.
t he same as the actual bath level in the machine.
Water Levels
1.1.1.2.
1.7.
W ater Level 6 must be the highest.
Temperature Probe
1.1.1.2.
1.8.
s ensor allows programming a sp
T emperature Unit
1.1.1.2.
1.9.
degrees Fahre
Steam Error
1.1.1.2.
1.10.
b ath temperature.
C ooldown Error
1.1.1.2.
1.11.
programmed bath
Extra Water
1.1.1.2.
1.12.
Reuse Drain
1.1.1.2.
1.13.
R inSave
—Set whether to allow RinSave steps in wash formulas.
1.1.1.2.
1.14.
Fill Error
—Set the maximum time allowed for the machine to fill to the desired level.
1.1.1.2.
1.15.
Counts per 10 RPMs
1.1.1.2.
1.16.
change the basket speed by 10 RPMs. Do not make a change to this value before you consult with
the Milnor factory.
Password Menu button
1.1.1.2.
1.17.
and manual functions. Also, set the date and time for the machine.
PELLERIN MILNOR CORPORATION
™
Control
—Set the type of goods this machine will process most often. This selection sets
ulas for the commercial configuration.
machine prompts. The only current choice is English.
—Set a digital counts value here so the displayed bath level on the Run scree
—Set a value for each water level. Water Level 1 must be the lowest level, and
—Set whether this machine has a temperature sensor. A tempera
ecific temperature for each bath step.
—Set whether bath temperature will be displayed and progr
nheit or degrees Celsius.
—Set the time allowed for the machine to use steam to achieve the programmed
—Set the time allowed for the machine to complete a cooldown to a
temperature.
—Set whether this machine is attached to a third water source.
—Set whether this machine has a reuse tank and a second drain valve.
—Set the number of counts from the digital-to-analog board required to
—Set a password to restrict access to programming, configuration,
ming. This version of the machine software
14
the
n is
ture
ammed in