Features; Connections And Controls; Speaker In/Thru - LD Systems MAUI i1 Bedienungsanleitung

FEATURES

· Passive column speaker for wall and ceiling installation with 9 x 3" mid-frequency drivers and 2 x 1" neodymium HF drivers
· Sophisticated passive crossover network for balanced frequency response
· Auto-reset overload protection for tweeters
· 120 W RMS capacity at 8 ohms
· Input selector: 8 ohms (transformer bypass) / 100 V / 70 V
· Four 100 V / 70 V transformer taps: 60 W / 30 W / 15 W / 7.5 W
· Transformer with extremely low saturation
· Consistent sound dispersion thanks to BEM-optimised waveguide; wide horizontal and controlled vertical sound dispersion
· U-bracket included in scope of supply, adjustable tilting bracket optionally available
· Four-pole terminal block connector for simple parallel connection of loudspeakers
· IP65 protected, aluminium speaker grille and weatherproof membrane for outdoor installation
· Available in 2 colours: white (RAL9010) and black (RAL9005)

CONNECTIONS AND CONTROLS

3
1
2
4
5 5
INPUT SELECT
1
4-way selector to match installation loudspeaker to a 70 V or 100 V installation amplifier or an amplifier
with low impedance output (8 Ω/120 W RMS). Select the appropriate position before connecting. Both
middle positions are intended for use with 100 V installation amplifiers.
POWER SELECT
2
4-way switch for selection of the required transformer tap (60 W/30 W/15 W/7.5 W). If 8 Ω/120 W RMS is
selected on the INPUT SELECT switch, the internal transformer is bypassed.

SPEAKER IN/THRU

3
Terminal block for connection of an installation amplifier and for sending the amplifier signal to the
additional loudspeakers in parallel (terminal block supplied). When wiring, please ensure correct
polarity (see illustration above terminal block).
COVER PLATE
4
For outdoor installations, use the supplied cover plate to protect the connectors and switches from
wetness and humidity. The cable glands in the cover plate
ternal diameter of up to 7 mm. Ensure that the rubber gasket is correctly positioned before securing the
cover plate to the speaker housing. Then tighten the locking nuts on the cable glands. Use the supplied
blanking plugs to seal any open cable glands if only one cable is used to control the speaker.
5 are suitable for round cables with an ex-
5