Hints And Tips - Electrolux TWGL3E300 Benutzerinformation

If the drying cycle is finished, the symbol
appears on the display. If the
Buzzer (Signal) option is activated, the
acoustic signal sounds intermittently for 1
minute.
If you do not turn off the
appliance, the anti-crease
phase starts (not active with
all programmes). Flashing
execution of the anti-crease
phase. Laundry can be
removed during this phase.
To remove the laundry:

9. HINTS AND TIPS

9.1 Ecological hints
• Spin the laundry well before drying.
• Do not exceed the load sizes which
are specified in the programs chapter.
• Clean the filter after each drying
cycle.
• Do not use fabric softener to wash
and then dry. In the tumble dryer
laundry becomes soft automatically.
• Use distilled water like that used for
steam ironing. If it is necessary, clean
the distilled water before (e.g. with a
coffee filter) to remove any particles.
• Always keep the airflow slots at the
bottom of the appliance clear.
• Make sure there is good airflow where
the appliance is to be installed.
9.2 Adjustment of default
dryness level
To change the default dryness level:
1. Turn the appliance on.
2. Wait approximately 8 seconds.
3. Select 1 of the available
programmes.
4. Touch and hold down the
Dryness (Trockengrad) and
Anticrease (Knitterschutz) buttons
at the same time.
One of the symbols appears on the
display:
- Maximum dryness
symbol signals the
1. Push the On/Off (Ein/Aus) button
for 2 seconds to turn the appliance
off.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Possible causes of unsatisfactory drying
results:
• Inadequate default dryness level
settings. See chapter
default dryness level
• Room temperature is too low or too
high. Optimal room temperature is
between 19°-24°C.
- Extra dryness
- Standard dryness
5. Touch the Start/Pause button
repeatedly until you reach the
desired dryness level.
Dryness
level
Maximum
dryness
Extra dry‐
ness
Standard
dryness
6. To memorise the setting touch and
hold down the
(Trockengrad) and
(Knitterschutz) buttons at the same
time for approximately 2 seconds.
9.3 Deactivating the tank
indicator
The water container indicator is activated
by default. It illuminates at the end of the
drying cycle or during the cycle if the
water reservoir is full. If the draining kit is
installed the water container is drained
ENGLISH
Adjustment of
Display symbol
Dryness
Anticrease
17