Hints And Tips - Electrolux TWSL5E300 Benutzerinformation

18 www.electrolux.com
If the drying cycle is finished, the symbol
Buzzer (Signal) option is activated, the
acoustic signal sounds intermittently for 1
minute.

10. HINTS AND TIPS

10.1 Ecological hints
• Spin the laundry well before drying.
• Do not exceed the load sizes which
• Clean the filter after each drying
• Do not use fabric softener to wash
• Use distilled water like that used for
• Always keep the airflow slots at the
• Make sure there is good airflow where
10.2 Adjustment of default
dryness level
To change the default dryness level:
1. Turn the appliance on.
2. Select 1 of the available programs.
3. Touch and hold down the
One of the symbols appears on the
display:
Downloaded from www.Manualslib.com
appears on the display. If the
If you do not turn off the
appliance, the anti-crease
phase starts (not active with
all programs). Flashing
symbol signals the execution
of the anticrease phase.
Laundry can be removed
during this phase.
are specified in the programs chapter.
cycle.
and then dry. In the tumble dryer
laundry becomes soft automatically.
steam ironing. If it is necessary, clean
the distilled water before (e.g. with a
coffee filter) to remove any particles.
bottom of the appliance clear.
the appliance is to be installed.
Silent (Extra Leise) and
Load (Dampf) buttons at the same
time.
- Maximum dryness
- Extra dryness
- Standard dryness
manuals search engine
To remove the laundry:
1. Push the
for 2 seconds to turn the appliance
off.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
4. Touch the
repeatedly until you reach the
desired dryness level.
Dryness
level
Maximum
dryness
Extra dry‐
ness
Standard
dryness
5. To memorise the setting touch and
hold down the
Leise) and
buttons at the same time for
approximately 2 seconds.
10.3 Deactivating the tank
indicator
Extra
The water container indicator is activated
by default. It illuminates at the end of the
Steam
drying cycle or during the cycle if the
water reservoir is full. If the draining kit is
installed the water container is drained
automatically and the indicator can be
deactivated.
To deactivate the indicator:
1. Turn the appliance on.
2. Select 1 of the available programs.
On/Off (Ein/Aus) button
Start/Pause button
Display symbol
Extra Silent (Extra
Steam Load (Dampf)