Care And Cleaning; Cleaning The Filter - Electrolux TWGL3E300 Benutzerinformation

18 www.electrolux.com
automatically and the indicator can be
deactivated.
To deactivate the indicator:
1. Turn the appliance on.
2. Wait approximately 8 seconds.
3. Select 1 of the available
programmes.
4. Touch and hold down
(Knitterschutz) and
(Zeitwahl) buttons at the same time.

10. CARE AND CLEANING

10.1 Cleaning the filter

At the end of each cycle the
(Sieb) symbol comes on the display and
you must clean the filter.
The filter collects the lint
during the drying cycle.
To achieve the best drying
performances clean the filter
regularly , clogged filter lead
to longer cycles and energy
consumption increase.
Use your hand to clean the
filter , and if necessary , a
vacuum cleaner .
CAUTION!
Avoid the use of water to
clean the filter. Instead throw
away lint in the dustbin
( avoid dispersion of plastic
fiber in water ambient).
1. Open the door. Pull the filter up.
2. Push the hook to open the filter.
One of 2 configurations is possible:
Anticrease
Time Dry
filter
3. Gather lint with hand from both
Throw the lint in the dustbin.
4. If necessary, clean the filter with a
5. If necessary, remove lint from the
• the tank (Behälter) indicator:
on if the symbol
- the water container indicator is
permanently activated
• the tank (Behälter) indicator:
off if the symbol
- the water container indicator is
permanently deactivated
internal parts of the filter.
vacuum cleaner. Close the filter.
filter socket and gasket. You can use
a vacuum cleaner. Place the filter
back inside the filter socket.
is
appears
is
appears