Operation - Go/on ZS-121007 Originalbetriebsanleitung

NOISE/VIBRATION INFORMATION
Measured sound values determined according to EN 62841.
Wear hearing protection!
Vibration total values (triax vector sum) determined according to EN 62841:
The vibration emission level given in this information sheet has been measured in accordance with
a standardised test given in EN 62841 and may be used to compare one tool with another.
It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main applications of the tool. However if the
tool is used for different applications, with different accessories or poorly maintained, the vibration
emission may differ. This may significantly increase the exposure level over the total working
period.
An estimation of the level of exposure to vibration should also take into account the times when
the tool is switched off or when it is running but not actually doing the job. This may significantly
reduce the exposure level over the total working period.
Identify additional safety measures to protect the operator from the effects of vibration such as:
maintain the tool and the accessories, keep the hands warm, organization of work patterns.
Vibration risk limitation suggestions:
1) wear glove during operation
2) limit operating time and shorten trigger time.

OPERATION

Before use
Remove any packing material and loose parts from unit.
Check the accessories before use. It should be fit with the machine and your purpose.
If the machine is new, the battery must first be charged.
Attention!
After long time storage, the battery capacity will be reduce.
Battery is equipped in the handle, press the battery retention clip, and remove battery from handle.
A substantial drop in operating period per charge indicates that the battery is worn out and must
be replaced.
Battery charger
The power voltage supply must conform to that specified on the rating plate of the rapid charger.
Always inspect battery charger, cord and plug before use.
Always have damage repaired by a qualified professional.
Protect battery charger against humidity and operate only in dry areas.
The supplied charger is suitable for charging batteries only.
LED indicator on charger: red indicator: charging. Green indicator: charge finished
Charging the battery
Remove the battery, plug the charger into the battery, then plug in the battery charger to the main
power. The battery and charger become warm during the charging process, this is normal.
After termination of the charging process (about 3-5 hours), pull charger plug out of mains socket
and plug charger from battery.
10
Press & pull