Desoutter E-LIT Serie Betriebsanleitung Seite 16

6159931420
Issue no : 16
Series : E
SPEED SETTING MODULE - V2
O
See page 8.
ANGLE HEAD ADJUSTMENT
P
See page 11.
NETWORK CONNECTION
(FOR ELC TOOLS)
Q
See page 12.
SPECIFIC COMMUNICATION LED
(FOR ELC TOOLS)
R
See page 12.
No communication to network.
See "Q" page 12.
Tool locked.
Batch complete.
Preventive maintenance.
ERROR CODES
Error
4 red flashing lights Clutch sensor error. The
5 red flashing lights Exceeding of the maximum
6 red flashing lights Tool overheating. The tool
16 / 108
Description
tool does not start or stops
instantaneously.
temperature (70°C). The
tool does not start or stops
instantaneously.
does not start or stops
instantaneously.
PREVENTIVE MAINTENANCE
It is recommended to lubricate (use Molykote
BR2+ grease) the clutch and the gearbox every:
- 500,000 cycles for 18V tools.
- 250,000 cycles for 36V tools.
ELC tools only
● Perform the maintenance of the
clutch every 500,000 cycles.
● Contact your local Desoutter
representative for the maintenance
procedure.
ASSEMBLY AND DISASSEMBLY
Follow standard engineering practices and
refer to figure for the mounting of component
subassemblies.
According to Directive 2012/19/
EC concerning Waste Electrical and
Electronic Equipment (WEEE), this
product must be recycled. Please
contact your "Customer Centre" or
consult the website
"www.desouttertools.com" to find out
where you can recycle this product.
Validation / Action
The signal given by the clutch sensor is out of
tolerances. Check the sensor and the magnets
joined to the sensor. Check the flex is correctly
connected to the electronic board. If the fault still
appears, contact our customer service.
The temperature measured with the electronic
board is higher than 70°C. Wait for the tool
cool down. The tool can tighten again when
the temperature is lower than approximately
70°C. Decrease the tool rate. If the temperature
is lower than 70°C and the fault still appears,
contact our customer service.
The power requested is too big. Do not use
the tool as a drilling machine. If the fault still
appears, contact our customer service.
11/2016