Specifications; Technical Data - Lenord+Bauer GEL 248 Betriebsanleitung

8 Specifications

8 Specifications
8.1

Technical data

Signal pattern
Electrical data
Supply voltage U (polarity
B
reversal protected)
Current consumption per chan-
nel I (without load)
B
Output signal (short-circuit-
proof)
Output level
Output signal level High
Output signal level Low
Output current per channel
Frequency range
(3)
Duty
Phase offset
Slew rate (2 m cable)
Dielectric strength
Requirements on the target wheel
Module m target wheel
(5)
Air gap permitted
Tooth shape target wheel
Material target wheel
Width target wheel
Permissible eccentricity
(1)
Output signal level dependent on the output current and the temperature
(2)
Depending on the output current and the temperature
(3)
Depending on target wheel and air gap
(4)
For the module of the standard versions, see type code
(5)
Depending on signal pattern and target wheel module. Pay attention to air gap table in this document.
40
Technical data
V
10 to 30 V DC
≤ 50 mA
Square-wave signals
HTL
(1)
≥ U - 2 V
B
(2)
≤ 1.5 V
≤ 20 mA
0 Hz to 20 kHz
50 % ± 10 %
typ. 90°
≥ 10 V/μs
720 V DC; as per DIN EN
60439-1
1.00 to 3.50
0.2 to 2.8 mm
Involute gear teeth according to DIN 867
Ferromagnetic steel
≥ 10 mm
≤ 0.3 mm
X
(4)
; others upon request
Lenord + Bauer
T
5 V ± 10 %
TTL
≥ 3.5 V
≤ 0.8 V
0 Hz to 25 kHz
50 % ± 5 %
500 V AC; as
per DIN EN
60439-1
0.2 to 3.0 mm
–
GEL 248