Philips FC9239 Bedienungsanleitung Seite 19

4222.003.3333.3.indd 19
- Turn the filter 180° and let the water flow along the pleats in opposite
direction.
- Continue this process until the filter is clean.
Never clean the washable filter with a brush.
Note: Cleaning does not restore the original colour of the filter, but does restore
its filtration power.
4 Carefully shake the water from the surface of the filter. Let the filter
dry at least 2 hours before you put it back into the vacuum cleaner.
5 Put the filter back into the appliance. Reattach the top of the filter
grille and push the bottom corners until they snap home ('click').
replacement
Batteries of remote control (specific types only)
1 Remove the lid of the battery compartment (1) and insert two AAA
1.5-volt batteries (2). Reattach the lid (3).
Make sure that the - and + poles point in the right direction.
storage
Before you store the appliance, always make sure you have cleaned the
filter cylinder by pressing the Filter-Clean button (see section 'Using the
Filter-Clean button' in chapter 'Using the appliance').
1 Switch off the appliance and remove the mains plug from the wall
socket.
English
19
09-07-09 15:09