Philips FC9239 Bedienungsanleitung Seite 17

4222.003.3333.3.indd 17
11 Press the Filter-Clean button.
12 For the best result, empty the dust bucket when the filter-cleaning
process is finished (see section 'Cleaning the dust bucket and filter
cylinder case').
Permanent motor protection filter
Clean the permanent motor protection filter every two months.
1 Unplug the appliance.
2 Take the motor protection filter out of the appliance. Clean the filter
by tapping the dust out of it over a dustbin.
If the motor protection filter is very dirty, you can also rinse it with cold tap
water.
Do not use washing-up liquid or any other cleaning agent to clean the
motor protection filter.
3 Press the clean filter firmly back into the filter compartment to
ensure that it is properly placed.
Make sure that the motor protection filter is completely dry before you
put it back into the filter compartment.
Super Clean Air HEPA 12 filter/Ultra Clean Air HEPA 13 filter
This appliance is equipped with either the Super Clean Air HEPA 12 filter
or the Ultra Clean Air HEPA 13 filter. These filters are located in the back
of the appliance. They are able to remove 99.5% and 99.95% respectively
of all particles down to 0.0003mm in size from the outlet air. This not
only includes normal house dust, but also harmful microscopic vermin
such as dust mites and their excrements, which are well-known causes of
respiratory allergies.
Note: To guarantee optimal dust retention and performance of the vacuum
cleaner, always replace the HEPA filter with an original Philips filter of the
correct type (see chapter 'Ordering accessories').
Super Clean Air HEPA 12 filter
Replace the Super Clean Air HEPA 12 filter every six months. This filter is
not washable.
1 Remove the filter grille.
English
17
09-07-09 15:09