Storch VacTec 25 M Installationsanleitung Seite 20

4.1
Push the intake opening of the PE
bag up to the stop in the vacuum
opening. Make sure that the inner
ring with its „open" mark remains in
position.
4.2
Now fold the protruding remainder
of the PE bag over the edge of the
catchment container; put the motor
unit back on the container, and close
the two latches.
The vacuum cleaner is now ready for
operation.
Comment:
As only the two air filter cartridges
directly touch the vacuumed material,
this does not impair the vacuuming
performance. Vacuum flow monito-
ring regularly shakes off the air filter
cartridges.
Translation of the original instruction
5.
Removing the PE bag: the PE bag
must be fully removed. To do so first
allow the vacuum cleaner to clean
the filter cartridges by shaking off
before slowly lifting off the vacuum
head. Tear the white sealing tape
off one side of the bag, lay the fil-
ters together at the top and tie these
with the tape. Pull the PE bag off the
vacuum opening and seal the opening
with the cap on the bag.
20