Preparing To Install - BESAFE iZi Modular A Handbuch

10

Preparing to install

• Adjustable head rest
• Shoulder pads (2x)
• Side support
• Shoulder straps (2x)
• Harness buckle
• Crotch bar
• Seat cushion
• Reclining handle
• Release handle head rest
• Front brace
Installation of the seat on the i-Size base
1. Check if the ISOfix and floor support indicators on the base are
green. (2)
2. Make sure that the front brace is installed on the base. The
operation of the front brace is described in the user manual for the
base. (2)
3. Make sure that the seat is always in the release position when you
want to install the seat on the base or take the seat off the base. The
two yellow arrows on the seat and the base must be aligned. (3) Use
the reclining handle to adjust the recline position, see step 6.
4. Position the seat in the correct position on the base untill it clicks
with the base and the indicator at the front shows green. (3)
5. When the seat is positioned rearfacing on the back seat of the
vehicle, you should, if possible, push the front seat of the vehicle
backwards, so that it is in contact with the child seat (4). If it is not
possible to obtain contact with the child seat, push the back rest of
the front seat of the vehicle forward as far as possible.
6. The seat can be taken off and turned around by pulling the seat
release handle at the front of the base (5,6). Make sure that the
two yellow arrows on seat and seatbase are aligned; this is the only
position where you can take off the seat.
7. The seat should only be turned around to forward facing when the
child is minimum 88 cm and 15 months. BeSafe recommends to use
the seat rearfacing for as long as possible.
8. When the seat is positioned forward facing, the front brace has to be
in position 1. (7)
9. The seat cannot be turned around in the BeSafe iZi Modular A RF.
This seat is only to be used rearfacing.
1a
1b
1c
1d
1e
1f
1g
1h
1i
1j