Troubleshooting; Ce Declaration Of Conformity - Wieland gesis KNX P CO Bedienungsanleitung

10. Troubleshooting

Fault
Lighting does not switch on
or switches off in case of
presence and darkness
With persons present, the
lighting is on although the
brightness is sufficient
Lighting does not switch off
or switches on spontaneously
in case of absence
Error blinking ( 4x per
second)

CE Declaration of Conformity

Product complies with the requirements of the directive 2004/108/EC.
36
Downloaded from www.Manualslib.com
Cause
Lux value setting is too low; Detector is in semi-
automatic mode; Lighting was switched off manually;
Person is outside the detection range; Detection is
disturbed by obstacle(s); Set switch-off delay setting
is too short; incorrect group adressing of detector -
actuator
Lux value setting is too high; The lighting has been
switched on manually recently; Detector is in test
mode
Wait until the switch-off delay time has elapsed (self-
learning effect); Disturbing heat sources within the
detection range (heaters, incandescent lamp/halogen
lamp, moving objects (e.g. curtains due to open
windows)
Failure during self test;
Device not working!
manuals search engine