Test Operation - Wieland gesis KNX P CO Bedienungsanleitung

6. Test Operation

Test operation is used to check the presence detection and connections (par-
allel switching master-slave, master-master).

● Set the detector to "Test Operation" using ETS (for parallel switching, set
all detectors to "Test Operation).
● The LED shows the movement signal immediately without switch-off
delay time.
● The lighting is switched on if motion is detected.
● If no presence is detected, the lighting is switched off after 10 sec.
● On completion of the test, set the presence detector to "Normal Operati-
on" using ETS.
● If "Test Operation" was set using ETS it cannot be terminated using the
remote control.
● If "Test Operation" was set using the remote control, it will end automati-
cally after 10 minutes.
Downloaded from www.Manualslib.com
The unit always reacts fully automatically in test operation.
Constant light control mode is not possible in test operation,
i.e. after switching on, the lights will always dim 100 %.
manuals search engine
GB
31