Start-Up Procedure; Programming Mode - Wieland gesis KNX P CO Bedienungsanleitung

4. Start-up procedure

4.1 Settings
All settings are adjusted using ETS. ETS2 V1.2 or newer is required.

4.2 Programming Mode

Programming mode can be selected either by using the programming button
on the back of the detector or, without unmounting the detector, using a ser-
vice remote control (optionally available).
4.3 Lighting Settings (recommended)
Brightness value
Setting the desired brightness (Lux)
● Transfer zones (non-working area)
● Working areas (office, etc.)
● Visually demanding work (laboratory, drawing,...)
Depending on the installation location, natural light intensity, furniture, reflec-
tion characteristics of the room and the furniture, an adjustment of the setting
by 1 or 2 steps may be necessary.
26
Downloaded from www.Manualslib.com manuals search engine
scale
approx. 3
approx. 4
> 5