Wieland gesis KNX P CO Bedienungsanleitung Seite 28

Lighting remains continuously in stand-by mode without presence. If the
room brightness is above the desired value, the lighting switches off; if it falls
below, the lighting switches automatically to stand-by mode, even if no one
is present.
4.4 Presence settings
Switch-off delay time presence
The settings remain unchanged (no self-learning effect).
Switch-on delay time presence
When switch-on delay is activated, the telegram sent when movement is de-
tected is delayed by the set value.
4.5 Switch-on behaviour
After every time the bus voltage is switched or the parameters are downloa-
ded by ETS, the detector runs through its start-up phase (indicated by LED).
1. Start-up phase (30sec.)
● LED blinks once per second
● Switching:
● Constant light control:
(Value telegram 100 %).
● If there is no presence or sufficient brightness, an OFF telegram is sent
after 30 sec. (Light off).
28
Downloaded from www.Manualslib.com
outlet light receives an ON telegram irrespective of brightness
control is inactive, lighting is maximum dimmed
manuals search engine