2. Operation:
●
The detector is ready for use
●
Switching:
switches on the lighting.
●
Constant light control:
lighting to the desired brightness.
●
If there is no presence or sufficient brightness, the detector switches the
lighting off.
5. Setting the Brightness Value
Using the service remote control (optionally available), the desired bright-
ness can be easily set.
●
Set the brightness by adjusting the artificial
light and blinds until the brightness in the
working area corresponds to the desired
value.
Example: 400 Lux is required in the wor-
king area. The blinds are adjusted so that
the light meter shows around 400 Lux.
●
In case of dimmable lighting, the brightness should be made up of half
artificial light and half daylight where possible.
Downloaded from
www.Manualslib.com
if there is presence and insufficient daylight, the detector
if there is presence, the detector sets the
manuals search engine
GB
200 Lux
29