Wieland gesis KNX P CO Bedienungsanleitung Seite 30

Example: 400 Lux is required in the working area. The blinds are adjus-
ted with the lights switched off so that the light meter shows around 200
Lux. The lighting is then gradually brightened, until the light meter shows
around 400 Lux.
● Using the "Brightness" menu on the remote
control, the values can be sent to the
detector in an increasing or decreasing
sequence.
● If the value sent is too small, the LED will blink briefly (error blinking), if
the value is too large, the LED will flicker for one second.
● A value which makes the detector flicker
straight away rather than show the error
blinking, (e.g. 4.3) must be entered in
the settings window on the ETS as the
brightness value. This value is now the
detector's new desired value.
● The desired value found in this way should take into account reflection and
influences such as furniture, installation location, incidence of light, etc.
30
Downloaded from www.Manualslib.com manuals search engine
3.9
4.0
4.1