Pelgrim GK210 Anleitung Seite 73

6 Faults
FAULT
A burner does not ignite.
The burner does not burn
evenly.
The burner goes out after
igniting.
CAUSE
Wrong type of gas used.
Control knob not kept
pressed in far enough.
Burner parts incorrectly
installed.
Burner parts dirty or damp.
Wrong type of gas used.
Control knob not kept
pressed in far enough.
SOLUTION
Check that the gas used is
suitable for the appliance. If
not, contact your gas fitter.
Keep the control knob
pressed in far enough
between full and low. At
first use this can take some
more time because of the
gas supply.
Assemble the burner parts
using the centring ridges.
Clean and dry the burner
parts, making sure that the
outflow holes are open.
Check that the gas used is
suitable for the appliance. If
not, contact your gas fitter.
Keep the control knob
pressed in for at least
5 seconds.
73