Network Setup - Wiseup AT003 Handbuch

3.1. Please make sure the Micro SD card has been formatted already and is securely fitted into
the camera's SD card slot, or it will not work. We recommend you to use a SDHC Class 10
Micro SD card.
3.2. Power on the camera by pressing the Power Button for 3 seconds. When the WIFI indica-
tor keeps flashing slowly, it means the camera's WIFI signal is ready.
3.3. If you need the camera to work 24/7 days, please plug it into an outlet power supply using
the included USB cable and power adapter.
IV. Network Setup
4.1. Install the "Camwf" APP on your iPhone or iPad
Search for "Camwf" in your App Store and install it on your iPhone or iPad.
4.2. P2P Connection Setup (LAN Mode)
4.2.1. Go to the WLAN Setting page on your iPhone or iPad, connect to the camera's WIFI
signal named "RT-*****". Wait until phone status bar appears WIFI symbol :
[Note]:
If the camera's WIFI signal cannot be found after a long time, please reset it (See VIII) or
recharge the backup battery only if the camera is powered by the backup battery.
4.2.2. Run the "Camwf" APP.
4.2.3. Add the camera to the "Camwf" APP as below:
Tap + > Search for the camera > Tap the camera's UID > Tap OK.
Downloaded from www.Manualslib.com manuals search engine