Residual Heat Indication; Power And Super Power Function; Timer - Novy 1719 Montageanleitung Und Bedienungsanleitung

Residual heat indication

After the switch off of a heating zone or the complete stop of the hob, the heating zones are still
hot and indicates [ H ] on the display.
The symbol [ H ] disappears when the heating zones may be touched without danger.
As far as the residual heat indicators are on light, don't touch the heating zones and don't put any
heat sensitive object on them. There are risks of burn and fire.

Power and Super Power function

Power [ P ] and Super Power [
If this function is activated the heating zones work during 10 minutes with an ultra high Power.
This is foreseen for example to heat up rapidly big quantities of water, like nuddles

Start up / Stop the Power:
Action
Start up the Power
Stop the Power

Start up / Stop Super Power
Action
Start up the Power
Start up Super Power
Stop the Super Power
Stop Powerr

Power management:
The hole cooking hob is equipped with a maximum of Power. When the Power function is
activated, and in order to exceed the maximum Booster, the electronic system orders to reduce
automatically the power level of an other heating zone. The display is blinking on [ 9 ] during a
few seconds and then shows the maximum of power allowed :
Heating zone selected
[ P ] is displayed

Timer

The timer is able to be used simultaneous with all heating zones and this with different time
settings (from 0 to 999 minutes) for each heating zone.

Setting and modification of the cooking time :
Action
Select the power level
Select theTimer
Decrease the time
Increase the time
After a few seconds, the [ min ] display stops with blinking.
The time is confirmed and the timer starts.
] grant a boost of Power to the selected heating zone.
Control panel
Slide to the end of the "SLIDER"
Or press directly on the end of
the "SLIDER"
Slide on the "SLIDER"
Control panel
Slide to the end of the "SLIDER"
Or press directly on the end of
the "SLIDER"
Re-press key [ P ]
Slide on the "SLIDER"
Slide on the "SLIDER"
The other heating zone:
[ 9 ] goes to [ 6 ] or [ 8 ] depending the type of zone
Control panel
slide on the "SLIDER"
Press simultaneously key [ - ] and [ + ] Timer display on
from the timer until the
desired display is on
Press key [ - ] from the timer
Press key [ + ] from the timer
51
Display
[ P ]
[ 9 ] to [ 0 ]
Display
[ P ]
[ and P ]
[ P ] to [ 0 ]
[ 9 ] to [ 0 ]
(example: Booster level 9)
Display
[ 1 ] to [ P ]
[ 60 ] to 59, 58...
Time increase