Charger Safety Instructions - Ryobi BD-336FL Bedienungsanleitung

GB
F D E
SPECIFIC SAFETY RULES
CORDLESS TOOL RULES
Cordless tools do not have to be plugged into an
electrical outlet; therefore, they are always
in operating condition. Be aware of possible
hazards when not using your cordless tool or
when changing accessories. Following this rule will
reduce the risk of electric shock, fire, or serious
personal injury.
Do not place cordless tools or their batteries near
fire or heat. This will reduce the risk of explosion
and possibly injury.
WARNING:
Batteries vent hydrogen gas and can explode in
the presence of a source of ignition, such as a pilot
light.
To reduce the risk of serious personal injury,
never use any cordless product in the presence
of open flame. An exploded battery can propel
debris and chemical. If exposed, flush with water
immediately.
Do not charge cordless tool in a damp or wet
location. Following this rule will reduce the risk
of electric shock.
For best results, your cordless tool should be
charged in a location where the temperature
is more than 10ºC but less than 38°C. Do not store
outside or in vehicles.
Under extreme usage or temperature conditions,
battery leakage may occur. If liquid comes
in contact with your skin, wash immediately with
soap and water, then neutralize with lemon juice
or vinegar. If liquid gets into your eyes, flush
them with clean water for at least 10 minutes,
then seek immediate medical attention. Following
this rule will reduce the risk of serious personal injury.
WARNING:
A damaged battery is subject to explosion.
To avoid serious personal injury, properly dispose
of a damaged battery.

CHARGER SAFETY INSTRUCTIONS

Save these instructions. This manual contains
important safety and operating instructions
for charger. Following this rule will reduce the risk
of electric shock, fire, or serious personal injury.
I P NL S DK
English
10
N FIN GR H CZ
Before using battery charger, read all instructions
and cautionary markings in this manual,
on battery charger, and product using battery
charger. Following this rule will reduce the risk
of electric shock, fire, or serious personal injury.
To reduce risk of injury, charge only nickelcadmium
and nickel metal hydride type rechargeable
batteries. Other types of batteries may burst
causing personal injury and damage. Following
this rule will reduce the risk of electric shock, fire,
or serious personal injury.
Do not expose charger to wet or damp conditions.
Following this rule will reduce the risk of electric
shock, fire, or serious personal injury.
Use of an attachment not recommended or sold
by the battery charger manufacturer may result
in a risk of fire, electric shock, or injury to persons.
Following this rule will reduce the risk of electric
shock, fire, or serious personal injury.
To reduce risk of damage to charger body and
cord, pull by charger plug rather than cord when
disconnecting charger. Following this rule will
reduce the risk of electric shock, fire, or serious
personal injury.
Make sure cord is located so that it will not be
stepped on, tripped over, or otherwise subjected
to damage or stress. Following this rule will reduce
the risk of serious personal injury.
An extension cord should not be used unless
absolutely necessary. Use of improper extension
cord could result in a risk of fire and electric shock.
If extension cord must be used, make sure:
a. That pins on plug of extension cord are the same
number, size and shape as those of plug on charger.
b. That extension cord is properly wired and in good
electrical condition.
Do not operate charger with a damaged cord
or plug. If damaged, have replaced immediately
by a qualified serviceman. Following this rule
willreduce the risk of electric shock, fire, or serious
personal injury.
Do not operate charger if it has received a sharp
blow, been dropped, or otherwise damaged in any
way; take it to a qualified serviceman. Following
this rule will reduce the risk of electric shock, fire,
or serious personal injury.
Do not disassemble charger; take it to a qualified
serviceman when service or repair is required.
Incorrect reassembly may result in a risk of electric
shock or fire. Following this rule will reduce the risk
of electric shock, fire, or serious personal injury.
RUS RO PL