Program Change; Program End - AEG TP4080TWC Benutzerinformation

14 www.aeg.com
8.5 Options
Together with the program you can set 1
or more special options.
To activate or deactivate an option touch
the relevant button or 2 buttons
combination.
When the option is activated, the LED
above the button or symbol illuminates
on the display.
8.6 Child lock option
The child lock can be set to prevent
children from playing with the appliance.
The child lock option locks all touch
buttons and the program dial (this option
does not lock the
button).
You can activate the child lock option:
• before you touch the
• after you touch the
Child lock option activation:
1. Turn the dryer on.
2. Select 1 of the available programs.
3. Touch and hold down 2 buttons at
The symbol
Downloaded from www.Manualslib.com
On/Off (Ein/Aus)
button - the appliance cannot start
button - programs and option
selection is unavailable.
the same time.
appears on the display.
manuals search engine
4. To deactivate the child lock, touch
the above buttons again until the
symbol disappears.
8.7 Starting a program
To start the program:
Touch the
The appliance starts and the LED above
the button stops flashing and stays on.

8.8 Program change

To change a program:
1. Push the
to turn the appliance off.
2. Push the
again to turn on the appliance.
3. Set a new program.

8.9 Program end

Start/Pause
Start/Pause
If the drying cycle is finished, the symbol
appears on the display. If the
Buzzer (Signal) option is activated, the
acoustic signal sounds intermittently for
1 minute.
Start/Pause button.
On/Off (Ein/Aus) button
On/Off (Ein/Aus) button
Clean the filter and drain the
water container after each
drying cycle. (See chapter
CARE AND CLEANING.)
If you do not turn off the
appliance, the anti-crease
phase starts (not active with
all programs). Flashing
symbol signals the execution
of the anticrease phase.
Laundry can be removed
during this phase.