Herunterladen Inhalt Inhalt Diese Seite drucken

Hints And Tips - AEG TP4080TWC Benutzerinformation

Vorschau ausblenden Andere Handbücher für TP4080TWC:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

To remove the laundry:
1. Push the

9. HINTS AND TIPS

9.1 Ecological hints
• Spin the laundry well before drying.
• Do not exceed the load sizes which
• Clean the filter after each drying
• Do not use fabric softener to wash
• Use distilled water like that used for
• Always keep the airflow slots at the
• Make sure there is good airflow where
9.2 Adjustment of default
dryness level
To change the default dryness level:
1. Turn the appliance on.
2. Select 1 of the available programs.
3. Touch and hold down the
One of the symbols appears on the
display:
4. Touch the
Dryness lev-
Maximum
dryness
Downloaded from
www.Manualslib.com
On/Off (Ein/Aus) button
for 2 seconds to turn the appliance
off.
are specified in the programs chapter.
cycle.
and then dry. In the tumble dryer
laundry becomes soft automatically.
steam ironing. If it is necessary, clean
the distilled water before (e.g. with a
coffee filter) to remove any particles.
bottom of the appliance clear.
the appliance is to be installed.
Dryness (Trockengrad) and
Refresh (Auffrischen) buttons at the
same time.
- Maximum dryness
- Extra dryness
- Standard dryness
Start/Pause button
repeatedly until you reach the
desired dryness level.
Display symbol
el
manuals search engine
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Dryness lev-
Display symbol
el
Extra dry-
ness
Standard
dryness
5. To memorise the setting touch and
hold down the
(Trockengrad) and
(Auffrischen) buttons at the same
time for approximately 2 seconds.
9.3 Deactivating the tank
indicator
The water container indicator is activated
by default. It illuminates at the end of the
drying cycle or during the cycle if the
water reservoir is full. If the draining kit is
installed the water container is drained
automatically and the indicator can be
deactivated.
To deactivate the indicator:
1. Turn the appliance on.
2. Select 1 of the available programs.
3. Touch and hold down
(Auffrischen) and
(Zeitwahl) buttons at the same time.
One of 2 configurations is possible:
• the tank (Behälter) indicator:
on if the symbol
- the water container indicator is
permanently activated
• the tank (Behälter) indicator:
off if the symbol
- the water container indicator is
permanently deactivated
ENGLISH
15
Dryness
Refresh
Refresh
Time Dry
is
appears
is
appears

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis