Alarm-Setting Mode - TFA Dostmann KlimaLogg Base Gebrauchsanweisung

Downloaded from www.Manualslib.com
The current dew point is displayed.
•
The time and date when the respective value was
•
determined are also displayed.
To clear the recorded max.min.-values, please
•
press and hold OK/MAX/MIN button for three
seconds in any mode.
All max./min. values will be deleted.
•
The display shows the current temperature and
•
humidity.
Max./min. values are not recorded in a data set.
ALARM SETTING MODE:
Press and hold the ALM button for the three
•
seconds.
The symbol for the upper alarm limit for the
•
humidity is flashing.
With the ALM button you can select one possible
•
alarm limit after the other:
- High limit humidity („HIGH AL RH", default 70%)
- Low limit humidity („LOW AL RH", default 20%)
- High limit temperature ("HIGH AL °C", default 40°C)
- Low limit temperature („LOW AL °C", default 0°C)
When displayed, the limit value can be changed by
•
pressing the "+" or "-" button.
In
•
"OK/MAX/MIN" button must be pressed while the
corresponding limit value is displayed.
If the alarm limit is activated, the alarm on/off
•
symbol is displayed as active on the toolbar (not
crossed out).
manuals search engine
Note:
order to activate an alarm limit,
27
the