Turn On The Computer - Panasonic Toughbook CF-20 Serie Bedienungsanleitung

2
2
1
3
1
3
2
B
4
4
2 Connect your computer to a power outlet
A Open the cover.
B Connect your computer to a power outlet.
The battery charging starts automatically.
CAUTION
l Do not disconnect the AC adaptor until the first-time operation procedure is completed.
l When using the computer for the first time, do not connect any peripheral device (including wired LAN
cable) except the battery pack and AC adaptor.
l Handling the AC adaptor
Problems such as sudden voltage drops may arise during periods of thunder and lightning. Since this could
adversely affect your computer, an uninterruptible power source (UPS) is highly recommended unless run-
ning from the battery pack alone.
l When the DC plug is not connected to the computer, disconnect the AC cord from your electrical outlet.
Power is consumed simply by having the AC adaptor plugged into an electrical outlet.
3 Open the display
A Pull out the handle.
l If you do not pull out the handle before opening the display, the computer may fall over due to the
weight of the display.
B Push down on the latch (B), and pull it out to release it.
C Hold the corners with both hands, and lift the display slightly.
D Hold the side of the computer with either of your hands and then lift up the display to open.
CAUTION
l Do not open the display wider than necessary (180° or more), and do not apply excessive pressure to the
LCD. Do not open or close the computer holding the edge of the LCD segment.
4

Turn on the computer

Press and hold the power switch
C
CAUTION
l Do not press the power switch repeatedly.
l The computer will be forcibly turned off if you press and hold the power switch for four seconds or longer.
l Do not perform the following operation until the First-time Operation is completed.
Ÿ Touching the release lever (E) and detach lock (F)
D
Ÿ Detaching the tablet from keyboard base
Ÿ Connecting or disconnecting the AC adaptor
E
Ÿ Pressing the power switch
Ÿ Closing the display
F Ÿ Any changes from the default setting of the Setup Utility
l Once you turn off the computer, wait for ten seconds or more before you turn on the computer again.
l When the CPU temperature is high, the computer may not start up to prevent overheating of the CPU.
Wait until the computer cools down, and then turn the power on again. If the computer does not power on
even after cooling down, contact Panasonic Technical Support (è
Manual).
(C) until the power indicator (D) lights.
Operating Instructions - Reference
11