Network Menu - T+A Caruso Bedienungsanleitung

Network menu

Status page
Network configuration
• Make sure that no LAN cable is connected to
the LAN 1 socket and that the WLAN antenna is
connected. (see chapter „Installation and Connec-
tion")
• Start the scan for available networks by tapping
on the scan button 1.
• The list 2 shows the detected WLANs.
• Select the desired WLAN by tapping it.
• The selected wireless network is displayed to the
SSID 3 field.
• Now tap into the field for the WLAN password 4
to open the keyboard.
• Enter the WLAN password and confirm with Enter
on the keyboard.
• Save the settings by tapping on Confirm 5.
A properly working home network (cable network or
j
WLAN network) with router and (DSL) Internet access
must be installed.
If you have any questions about installation, setup
and the general configuration of your network, plea-
se contact your network administrator or a network
specialist.
58
(WLAN setup)
This shows if the device has a network
connection and if it is connected via
wired LAN or WLAN.
IP adress
MAC adress
If a WLAN connection is used, the
name of the selected network is
displayed here.
Signal strength of WLAN connection
The network interface can be reset
here.
Opens the WLAN configuration menu
Depending on the bandwidth of your
Internet and network connection, you can
select the sound quality (bit rate) of the
streamed content here.
Select the quality level in order to avoid
dropouts during playback.
5
1
2
3
4