Salter 9500 Gebrauchsanleitung Seite 3

The Salter luggage scale has a simple one button operation. Compact and light it can be stored neatly within
your luggage when you are travelling.
PREPARING YOUR SCALE
1. Remove battery isolator tab from rear of scale.
2. The scale is set to kg weight mode. To change default to lb take the following steps:
3. Ensure scale is switched off.
4. Press button to switch scale on. While display shows '8.8.8' press button again until desired weight mode is
shown on right of display.(kg / lb)
5. Wait for display to show '0.0' . Scale is ready for use.
LIFTING GUIDE
• Important - if you cannot comfortably lift your luggage
do not attempt to weigh it.
• Stand with luggage to your side.
• Hold scale with one hand only.
• Keeping back straight, bend knees then lift.
• Look ahead, not at the display, while lifting.
The scale will beep to alert you once the weight reading has been taken.
• Avoid twisting the back or leaning sideways.
Keep shoulders level and facing same direction as hips keeping back upright at all times.
• Keep luggage close to the body but not touching.
• Luggage only needs to be just clear of floor to take reading.
• Lift smoothly.
• When measurement is complete, lower the luggage in the reverse manner you lifted.
(Figure 1 shows the correct lifting method)
OPERATING YOUR SCALE
1. Attach strap around luggage handle with buckle facing you. Ensure buckle is securely engaged and strap
adjusted to take up excess.
2. Hold scale with one hand. Allow strap to dangle beneath scale to enable an accurate zero reading.
3. Press button to switch scale on. Wait until display shows zero.
4. Gently lift scale until luggage is off the floor.
5. When a stable weight reading is achieved the scale will beep.
6. Lower the luggage to the floor.
7. Weight is displayed for approximately 1 minute before switching off, or press button to switch off.
Figure 1
3
GB