Maintenance, Repair And Disposal - autosen AW001 Montageanleitung

The inclination sensors are fitted with two round 4-pole M12 connectors (class A)
in accordance with IEC 60947-5-2. The M12 connectors are mechanically A-coded
in accordance with IEC 61076-2-101.
1: L+ 24 V DC (+Ub-D)
2: OUT2 switching output 2
3: L- mass (GND)
4: OUT1 switching output 1 oder IO-Link
1: L+ 24 V DC (+Ub-D)
2: OUT2 analogue output 2
3: L- mass (GND)
4: OUT1 analogue output 1
5 IO-Link
General information
This unit has an IO-Link communication interface (via pin 4) which requires an
IOLink-capable module (IO-Link master) for operation.
The IO-Link interface enables direct access to process and diagnostic data.
Communication via a point-to-point connection is possible with IO-Link Master.
You will find the IODDs and parameter setting tools necessary for the configurati-
on of the IO-Link unit at www.autosen.com.
6 Technical data, approvals/standards
Detailed manuals, technical data, EC declaration of conformity, approvals and
further information can be found at www.autosen.com.

7 Maintenance, repair and disposal

The unit is maintenance-free.
► Dispose of the unit in accordance with the national environmental regulati-
ons.
2 1
M12-connector (left)
3 4
2 1
M12-connector (right)
3 4
UK
5