gc Labolight DUO Gebrauchsanweisung Seite 9

■ Do not touch the LED unit and its surroundings after using the unit for a long time. Otherwise, burn injury
could be caused.
■ Maintenance, if intended after a prolonged use, should be conducted after the unit temperature suffi ciently
lowers.
< General >
■ Take care to ensure the stability of the unit in relation to inclination, vibration, and impact, for example.
■ In case the unit fails or damages, stop using the unit immediately, turn off the main switch, and pull out the
power plug.
■ Do not attempt to repair the failed unit by yourself but request an expert to do it after providing an
appropriate indication thereon.
■ Do not use the unit with wet hands. Otherwise, the unit could fail.
■ Do not splash water (or other liquids) on the unit.
■ Do not handle liquid or metal powder in the curing chamber. In case liquid or dangerous material
accidentally enters into the chamber, stop using the unit and request for repair.
< Installation, assembly, and storage >
■ Do not install the unit in a place where chemicals are stored or gas is generated.
■ Do not place fl ammable objects near the main body. Otherwise, fi re could be caused.
■ Do not place any equipment susceptible to light or heat in the unit's surroundings.
■ Pay attention to the power source in terms of its frequency, voltage, and allowable current (or power
consumption).
■ Use the attached dedicated power cord and AC adapter.
< Usage >
■ Do not open / close the door swiftly. Otherwise, the door or the object inside the curing chamber could be
damaged.
■ When opening / closing the door, do not allow your hand or part of your body or the object to enter into
below the door or the gap. Otherwise, personal injury or property damage could be caused.
■ Do not touch the rotating turntable. Otherwise, your fi ngers could be caught or the turntable could be
damaged.
■ If anything is caught by the turntable, stop the turntable rotation by pressing the stop switch or turning off
the main switch before removing the caught object.
■ Clean off contamination of the lens cover or replace the contaminated cover. Otherwise, the contaminated
portion is heated to cause deformation or melting of the cover.
■ Arrange an object subject to curing with its curing surface facing the light source.
■ Set curing time suitably for the use material.
■ Be sure to verify the material for perfect curing upon the completion of curing. In case of insuffi cient curing,
additionally irradiate light.
■ Do not directly hold and cure a composite in hands in the step mode. Otherwise, burn injury could be
caused by the hot composite.
■ Do not remove a composite immediately after curing directly with hands in the full mode.
Otherwise, burn injury could be caused by the hot composite.
< Maintenance >
■ Be sure to perform regular checkup of the equipment and components.
■ Be sure to clean the curing chamber regularly, as otherwise, the contaminated chamber could not exercise
suffi cient curing performance. If fl ammable disinfectant is used (e.g. Isopropyl alcohol based), there is risk
of ignition/explosion if lamp is started with vapors in the chamber.
■ Replace the lens cover regularly. Otherwise, the performance could be deteriorated due to aging and
contamination.
■ If the unit is used without the lens cover mounted, the performance could be deteriorated due to
insuffi cient protection of the lens. Be sure to use the unit with the cover mounted.
Downloaded from www.Manualslib.com manuals search engine
CAUTION
CAUTION
EN 7