Use Method; Basic Use Method - gc Labolight DUO Gebrauchsanweisung

5. Use Method

5.1 Basic use method

● Verify normal operation of the unit prior to use.
● Pay special attention to the following during use of the unit:
- Monitor the entire unit for any fault at all times.
- In case of any fault found on the unit, take appropriate action such as shutting down the unit.
■ Light-sensitive personnel such as those allergic to light are prohibited to use the unit. In addition, care
must be taken for irradiation light not to shine on light-sensitive people such as those allergic to light.
■ Personnel equipped with a heart pacer should not use the unit.
■ Otherwise, the pacer could malfunction.
■ When repairing a prosthesis removed from patient's oral cavity, disinfect it prior to placement in the unit.
Otherwise, infection could be caused.
1) Turn on the main switch and verify that something appears on the time display.(see Item 3.2.2)
2) Cure a composite in the step mode (see Section 5.2) or full mode (see Section 5.3).
■ Do not directly look at the irradiation light. Otherwise, eyes could be damaged.
■ Do not irradiate light on an object located closer to the light source than being recommended. Otherwise,
the object could be heated.
■ Do not bring your hands close to the irradiating light source. Otherwise, burn injury could be caused.
■ Wear suitable protective equipment such as glasses that cut off light with a wavelength of 500 nm or less
when continuously working on the unit for a long time or if you are sensitive to light or have a cataract or
damaged retina, for example.
■ To operate the switch, use your fi ngers but not any sharp tool.
■ When opening / closing the door, do not allow your hand or part of your body or the object to enter into
below the door or the gap. Otherwise, personal injury or property damage could be caused.
■ Arrange an object subject to curing with its curing surface facing the light source.
■ Set curing time suitably for the use material.
■ Be sure to verify the material for perfect curing upon the completion of curing. In case of insuffi cient curing,
additionally irradiate light.
■ Clean off contamination of the lens cover or replace the contaminated cover. Otherwise, the contaminated
portion is heated to cause deformation or melting of the cover.
EN 16
Downloaded from www.Manualslib.com manuals search engine
Note
WARNING
WARNING
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION