Herunterladen Inhalt Inhalt Diese Seite drucken

Cleaning Method Of Respective Portions - gc Labolight DUO Gebrauchsanweisung

Lichthärtungs-gerät mit dualer led-lichtquelle für indirekte komposite
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 32
■ Turn off the main switch and plug off the power cord prior to cleaning or parts replacement.

6.2.1 Cleaning method of respective portions

■ Be sure to clean the curing chamber regularly, as otherwise, the contaminated chamber could not exercise
suffi cient curing performance.
Contents
Lens cover
Turntable
Step mode switch
Visor
Housing, Curing
Chamber
Curing stand
holder
Tray
Metal post
Clip
Curing plate
Curing stand
Silicone post
● For cleaning the unit, use a soft cloth wetted with a small amount of water or alcohol. In addition, do not
use organic solvent (thinner, benzine, etc.).
● Care should be taken for the unit being possibly whitened in the portion where organic solvent attaches.
Immediately wipe off such a solvent if attached.
EN 22
Downloaded from
www.Manualslib.com
Wipe off with a soft cloth wetted with a small amount of water or alcohol.
* In case of any discoloration, contamination or scratches cannot be cleaned, replace the lens cover.
* Lens cover potentially be discolored by aging.
■ Clean off contamination of the lens cover or replace the contaminated cover. Otherwise, the
contaminated portion is heated to cause deformation or melting of the cover.
■ If the unit is used without the lens cover mounted, the performance could be deteriorated due
to insufficient protection of the lens. Be sure to use the unit with the cover mounted.
Wipe off with a soft cloth wetted with a small amount of water or alcohol.
* Pull up the turntable for removal.
* When remounting the turntable, rotate it to find one of the six positions (provided at an interval of
60 degrees) where the turntable enters deeply into the bottom.
Wipe off with a soft cloth wetted with a small
amount of water or alcohol.
For dirt accumulated in a clearance, remove the
step mode switch cover and clean by using a
cotton swab, for example.
(for removal method, see Item 6.2.3)
Wipe off with a soft cloth wetted with a small amount of water or alcohol, in principle.
Wipe off with a soft cloth wetted with a small amount of water or alcohol, in principle.
Wipe off with a soft cloth wetted with a small amount of water or alcohol, in principle.
Wipe off with a soft cloth wetted with a small amount of water or alcohol, in principle.
* Disinfection with chemical solution allowed.
* Autoclave sterilization possible
Wipe off with a soft cloth wetted with a small amount of water or alcohol, in principle.
* Disinfection with chemical solution allowed.
* Autoclave sterilization possible (However, repetitive operation causes deterioration.)
manuals search engine
CAUTION
CAUTION
Details
CAUTION
Note

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis