Step Mode - gc Labolight DUO Gebrauchsanweisung

3) After use, close the door and turn off the main switch. (see Section 4.6)
■ Do not touch the LED unit and its surroundings after using the unit for a long time. Otherwise, burn injury
could be caused.
● When not using the unit for a long time, unplugging the power cord is recommended for energy saving.

5.2 Step mode

●Use the step mode only for pre-curing.
1) Open the door and verify the door open indicator being lit.
(Standby status in the step mode)
2) Place an object subject to curing in the recommended curing position (described below) and press the Step
mode switch.
- Light irradiation only by upper LEDs immediately starts and remaining time appears on the time display.
- Ten seconds is added to the remaining time by additionally pressing the Step mode switch with light
irradiation in progress.
- The maximum 30 seconds of addition is possible.
■ Do not look in the unit for monitoring irradiation light in the step mode. Otherwise, eyes could be damaged.
■ Avoid continuously looking at refl ected lights by appropriately taking intermission when working on the unit
in the step mode for a rather long time. Otherwise, discomfort could be felt.
■ Do not bring your hands close to the irradiating light source. Otherwise, burn injury could be caused.
■ When irradiating a prosthesis in the step mode, avoid locating your hands
between the light source and the turntable as much as possible by using
a crown clamp, for example. Otherwise, tanning could be caused due to a
prolonged use.
■ Do not directly hold and cure a composite in hands in the step mode.
Otherwise, burn injury could be caused by the hot composite.
3) Upon the completion of light irradiation, remove the object subject to curing.
* Using the unit for a long time may result in blinking of the overheat indicator due to excessively high
temperature of LEDs (temperature warning). With the occurrence of temperature warning, taking intermission
for the period equivalent to the previous curing time is recommended.
* A further rise in temperature will result in a forced stop of operation for allowing the LEDs to cool down,
thereby irradiation being disabled.
Downloaded from www.Manualslib.com
CAUTION
CAUTION
manuals search engine
CAUTION
Note
Note
CAUTION
7
9
11
EN 17