Stoppage And Storage - gc Labolight DUO Gebrauchsanweisung

■ Do not continuously look inside the curing chamber through the window for a long time in the full mode.
Otherwise, discomfort could be felt.
■ In case the unit fails or damages, stop using the unit immediately, turn off the main switch, and pull out the
power plug.
● Before using the unit after a prolonged stoppage, be sure to verify that the unit operates normally and
safely.

4.6 Stoppage and Storage

1) Close the door and turn off the main switch.
● When not using the unit for a long time, unplugging the power cord is recommended for energy saving.
■ Do not insert or pull out the plug with wet hands. Otherwise, electric shock could be caused.
■ When disconnecting cords, do not exert excessive force thereon by, for example, holding them for pullout.
2) Clean the unit to prepare for smoothly starting the next operation (see Chapter 6, "Maintenance").
■ Be sure to clean the curing chamber regularly, as otherwise, the contaminated chamber could not exercise
suffi cient curing performance.
3) Store the unit with care for the following:
− For temperature, humidity, and atmospheric pressure in the storage environment, see Chapter 9,
"Specifi cations."
■ Take care to ensure the stability of the unit in relation to inclination, vibration, and impact, for example.
● Install the unit in a place where not receiving any adverse effect from direct sunlight, dust, dampness, air
containing salt and sulfur, or a heater nearby.
● Install the unit in a place where no water splashes.
Downloaded from www.Manualslib.com manuals search engine
CAUTION
CAUTION
Note
Note
CAUTION
CAUTION
CAUTION
Note
EN 15