Control Panel - gc Labolight DUO Gebrauchsanweisung

3.2.2 Control panel

No.
[B-1]
[B-2]
[B-3]
[B-4]
[B-5]
[B-6]
[B-7]
[B-8]
Other operating unit
[A-13]
EN 10
Downloaded from www.Manualslib.com
[B-2]
[B-3]
Name
Display Displays statuses of various devices.
Step mode indicator Lit during irradiation in the step mode.
− Displays remaining time of irradiation in the step or full mode.
− Blinking display of time indicates a temporary halt.
Standby status with the door opened
(= standby status in the step mode)
Standby status with the door closed
Time display (= standby status in the full mode)
When the full mode is properly
completed, "Fin" is displayed.
If an error occurs, an errornumber is
displayed.
Unlit: Indicates the door closed.
Door open indicator
Lit: Indicates the door opened.
Blinking: Temperature alarm
− Alerts high temperature of LEDs due to continuous use.
Over heat indicator − Ensure a sufficient intermission, as the LEDs are nearly overheated.
Lit: Overheat
− Lit if irradiation is temporarily halted due to high LED temperature.
Lit if an error occurs.
Error indicator
(For details of errors, see Chapter 7, "Troubleshooting.")
A press starts irradiation in the full mode.
Curing time key The time of irradiation is 1, 1.5, 3, and 5 minutes, respectively.
(1 / 1.5 / 3 / 5) Successive presses add time, enabling continuous irradiation for as long as
10 minutes.
Press it when stopping irradiation in the step or full mode or when resetting a
Stop key
temporary halt.
A press starts irradiation for 10 seconds in the step mode.
Step mode switch Successive presses add time, enabling continuous irradiation for as long as
30 seconds.
manuals search engine
[B-1]
[B-7]
Information
[B-4]
[B-5]
[B-6]
[B-8]