Hitachi RAK-25PSEW Handbuch Seite 6

FILTER CLEANING UNIT OPERATION CHECK
Performing operation check after the power is turned on.
Perform the filter cleaning unit operation check
• After the power is turned on (after the circuit breaker is switched on or power failure), the cleaning unit
makes one cycle of back and forth movement.
• At this time, the (FILTER CLEAN) indicator is lit.
• One cycle of operation check will take approximately 8 minutes.
• During the operation check, the unit performs "Fan" operation while horizontal air deflector remain closed.
• If the (FILTER CLEAN) indicator blinks (lit for 4 seconds/off 1 second) after the operation check, refer to
"Troubleshooting" on page 14.
Dust catcher
• The illustration shows the unit without front
panel for your reference only.
Cleaning Unit
There is a filter cleaning wiper inside.
CAUTION
Do not put your fingers or a stick etc into the top surface during
the filter cleaning operation
It may result in injury or malfunction.
- 6 -
.