Headrest; Seat Angle - Vermeiren Alesia Gebrauchsanweisung

B
HEADREST (OPTIONAL)
•
The headrest is inserted into the retainer of the back section (A) and the pillow height can be adjusted.
The pillow can be removed or attached using the pushbutton on the lower end of the sliding plate on
the pillow.

SEAT ANGLE

An attendant can use the pneumatic spring to angle the seat unit, gradually, up to 12°, into the most
comfortable position, and to angle it forwards up to 3° to assist the patient to get in and out of the
chair.
With your foot, gently press downwards the release lever (highlighted in blue) on the right rear wheel
for the seat angle and adjust the seat unit to the position you want, by clutching the handle and
pushing the seat down or pulling it up. To fix it in the position you want, take your foot off the release
lever.
L
L
If you wish to move a patient, you should always select a gentle seat angle or the footplate (if
in use) will drag along the ground while doing so.
Downloaded from www.Manualslib.com
Guide the safety pin (1) through the rear retainer and the pneumatic spring. Then tighten the
safety pin (1) by guiding the tension spring (4) over the pin until the pin juts out above the end
of the locking pin.
A
Ensure that the rear wheel is not underneath the blue release lever, blocking it.
Take care, when adjusting the seat angle, that the wheelchair does not start moving if the
brake is not holding it in place.
manuals search engine
5
E
ALESIA
06/2009