Connecting the hob to the main power supply
15. Connecting the hob to the mains power supply
The power supply should be connected in compliance with the rele-
vant standard, or a single-pole circuit breaker.
The method of connection is shown below.
1 x 220-240V~
32A
2 x 230V 2N~
16A
blue and white do not disconnect!
please contact customer service.
• If the cable is damaged or needs replacing, this should be done by
an after-sales technician using the proper tools, so as to avoid any
accidents.
• If the appliance is being connected directly to the mains supply,
an omnipolar circuit breaker must be installed with a minimum
gap of 3mm between the contacts.
• The installer must ensure that the correct electrical connection
has been made and that it complies with safety regulations.
• The cable must not be bent or compressed.
• The cable must be checked regularly and only replaced by a pro-
perly qualified person.
• The installer must use the H05GG-F power cord.
46
Device is not suitable for
operation with an EU plug!
Note:
Hob blue and white connect
in box on blue clamp.
Black on L1, brown on L2.
If you are not sure,