Fastening The Counter; Attaching The Seal - Agreto VibroCounter II Benutzerhandbuch

AGRETO VibroCounter II
7.3

Fastening the counter

Place the counter on the base plate.

Use the 4 allen screws M5x8. Two of them

have a small hole for the seal wire, use these
two on the side where you want to attach the
seal.
First, pull slightly down all 4 screws, and

then tighten every screw again so that the
housing is evenly pressed against the
mounting plate.
7.4

Attaching the seal

Thread the seal wire through the holes in the

two screws.
Thread both ends of the wire through a hole

in the seal.
Slide the seal as close as possible to the

meter and at the same time tighten the wire.
Close the seal.

If the hole of one of the screws is not accessible,
you can also drill a small hole in the housing bar
between the two screws and pull through the seal
wire here.
© AGRETO electronics GmbH page:9