Setting The Parameters - Agreto VibroCounter II Benutzerhandbuch

AGRETO VibroCounter II
Button Definition
M Menu
- Minus
+ Plus
6.2

Setting the parameters

To open the parameter menu, briefly press the "M" key. The first parameter that
is relevant for the set operating mode appears on the display.
The name of the parameter is displayed for two seconds, then the set value
appears.
Use the "+" or "-" keys to change the value of the parameter.
Use the "M" key to change to the next parameter, the set value is saved. After
the last parameter, the first parameter is displayed again.
To exit the menu, press and hold the "M" button for three seconds, or simply
wait 10 seconds without pressing a button. The counter then restarts.
Parameter SENS - Sensitivity
This parameter determines from which intensity of a movement the count is
triggered, ie how strong the vibration or movement must be. The higher the
value, the stronger the movement must be to trigger or continue the count.
0 = highest sensitivity (counts even on very small movements)
2 = a running internal combustion engine is already detected
4 = default
10 = lowest sensitivity (only counts for extreme movements)
The parameter SENS is related to the parameter hoLd, since a movement must
always have a certain intensity and must be present for a certain period of time
in order to trigger the summation.
© AGRETO electronics GmbH
Entry into the menu
Continue to the next parameter, exit from the menu
Back to the previous step
Decrease a parameter by 1
Continue to the next step
Increase a parameter by 1
Function
page:6