Zeroing The Counter - Agreto VibroCounter II Benutzerhandbuch

AGRETO VibroCounter II
Parameter hoLd – Holding time
This parameter determines the length of a rest period in seconds, during which
the count continues without interruption. If another movement follows within the
set time (which is strong enough), the complete time is added up, including the
rest phase.
1 = summation is stopped immediately at the end of the movement
60 = default
100 = a rest period of up to 100 seconds is counted
Parameter UnIt - Display format
This parameter determines the format of the hour display.
00:59 = default setting, display in hours and minutes (hhhh:mm)
00,99 = display in hours with 2 decimal places (hhhh,hh)
By default, the display is in hours and minutes, and the colon is used as the
separator.
If necessary, you can change the display to decimal hours, here the comma is
used as separator.
6.3

Zeroing the counter

To reset the counter, press and hold all 3 buttons together for 3 seconds. When
released, the total is set to 0.
© AGRETO electronics GmbH page:7