Sharp XE-A102 Bedienungsanleitung Seite 8

Preparing the Cash Register
Step 3 Install Batteries
Three new R6 or LR6 batteries ("AA"size) must be installed in the cash register to prevent the data
and user-programmed settings from being erased from the memory, when the AC cord is
accidentally disconnected or in case of power failure. Once installed, the batteries will last
approximately one year before needing replacement. At this time, the " " symbol will appear on
the display to indicate that the batteries are low and that you must replace them within two days.
Install three new R6 or LR6 batteries ("AA"size) according to the procedure shown below with the
AC cord connected and set the mode switch to the REG position:
1. Push the printer cover forward and detach it.
2. Open the battery cover next to the paper roll cradle.
3. Insert three new R6 or LR6 batteries ("AA"size).
4. Confirm the no battery symbol "
5. Close the battery cover.
Be sure to observe precautions shown on page 1 when
handling batteries.
Step 4 Install the Paper Roll
On your register, a printer is mounted, and you can print receipts or journals. For the printer, you
must install the paper roll provided with the register, even when you program the register for not
printing receipt.
1. Set the paper roll in the paper roll cradle as shown in the
diagram.
6
" lights off.
(Views from rear)