WIKA A2G-25 Betriebsanleitung Seite 18

5. Commissioning, operation
5.3 Output signal setting
The analogue output signal of the model A2G-25 air flow meter can
be set between 0 ... 10 V and 4 ... 20 mA. The setting can be made via
jumpers on the printed circuit board.
EN
Installing the jumpers
(Dark grey colour indicates the jumper placement)
1
 Fitting the jumper to the slots, upper left/middle:
Output signal for the air flow: 4 ... 20 mA
 Fitting the jumper to the slots, middle/below:
Output signal for the air flow: 0 ... 10 V
 Fitting the jumper to the slots, upper right/middle:
Output signal for the differential pressure: 4 ... 20 mA
 Fitting the jumper to the slots, right middle/below:
Output signal for the differential pressure: 0 ... 10 V
4-20 mA
Out
1-10 V
1
18
Downloaded from www.Manualslib.com
4-20 mA
Out
1-10 V
2
4 ... 20 mA
Out
1 ... 10 V
2
manuals search engine
3
3
WIKA operating instructions model A2G-25
4
4