Programming A Cooking Zone - Candy PVD 603 Installations- Und Bedienungsanleitung

To stop the additional zone:
the cooking zone with addition must be live: in the display zone, the lamp must be on.
If not, select the relevant zone again.
. Press the button
tional cooking zone goes off.
. To rapidly stop the complete cooking zone, press the
time. The heat level automatically goes down to

• PROGRAMMING A COOKING ZONE

Every cooking zone can be programmed for a maximum time of 99 minutes. Only one
zone, at a time, can be programmed.
. Start the required zone by following the previous instructions.
The control LED near the heat level must be displayed, it shows that the zone is live.
. Press the Timer button.
The zone mark around the timer display shows the controlled zone.
. Press the button to select
the time in minutes.
L'enregistrement est automatique après trois secondes.
The programmed time can be modified at any moment by pressing the timer
selection button, the timer control LED must be on.
When the time has run, the cooking zone goes off automatically and an audible beep
sounds for 1 minute. Press any button to stop it.
The programmed time can be reset to
and buttons at the same time, the cooking zone is then no longer linked to the
timer but stays operational. So you will have to stop the zone manually.
The timer can be used alone as a reminder, it will ring at the end of the programmed
time.
. According to model, additional zone Led disappears. The addi-
or
. The cooking zone goes off.
using the button and pressing the
button at the same
- 47