Installation - Fitting - Candy PVD 603 Installations- Und Bedienungsanleitung

INSTALLATION – FITTING
The unit or support for the hob, as well as the walls of any adjacent units, must be made
of high temperature resisting material. In addition, the laminate covering the unit or
support should be laid using heat-resistant adhesive to prevent it coming away.
Installation:
• A seal is supplied with the hob. To install it,
. turn over the hob, glass side down, taking care to protect the glass.
. place the seal all round the hob.
. make sure it is placed correctly to prevent any ingress into the support unit.
Seal
• The body of the hob is fitted with 4 locations holes (Ø 3 mm) to take the fixing
clamps intended to fix the hob in the unit. Place the 4 fixing clamps, in such a way
that the hob is placed perfectly in the support unit.
• Leave a gap of at least 5 cm between the appliance and any neighbouring vertical
surfaces.
• If, according to the hob's installation, the casing bottom is near a zone normally
accessible during handling and/or storage, install a partition 1 cm from the casing
bottom, to prevent any risks of burns or deterioration.
Hob casing
Hob with glass side down
Hob glass or
frame
- 41