Measuring Blood Pressure - Fora DUO ultima D40 Bedienungsanleitung

Measuring Blood Pressure

This device provides you two different ways to measure your blood pressure.
When the device detects an irregular heart beat, the pulse rate symbol is shown as "
" instead of "
Important!
Always apply the pressure cuff before turning on the device.
A. Single Measurement
Perform an individual blood pressure measurement.
1. Press . All the LCD symbols will appear.
2. Press to select the desired user number and then press
begin to inflate automatically.
A pulse is detected.
3. Press to turn the device off.
Note:
• If the device is idle for 3 minutes, it will turn off automatically.
B. Average measurement
Automatically perform three (3) consecutive blood pressure measurements and
display the final average result.
1. Enter the Average mode.
Press and hold
model).
2. Press to select the desired user number and then press
begin to inflate automatically.
After the first measurement is complete, the
device will start counting down before the second
measurement begins. The device will take three (3)
measurements consecutively with an interval of 20
seconds.
After taken three measurements, the results are averaged to produce
the blood pressure measurement.
3. Press to turn the device off.
" . If the problem still persists, please consult your doctor.
for 3 seconds (for D40b/D40g model), or just press
Displays the systolic pressure, diastolic
pressure, and pulse rate.
EN-10
D40 Owner's Manual
. Then the cuff will
(for D40a
. Then the cuff will