Measuring Blood Pressure; Single Measurement - Fora Diamond Cuff BP Bedienungsanleitung

Measuring Blood Pressure

This device provides you different ways to measure your blood
pressure.
When the device detects an irregular heart beat, the IRB symbol
is shown as " " instead of "
please consult your doctor.
Important!
Always apply the pressure cuff before turning on the device.
A. Single Measurement
Perform an individual blood pressure measurement.
1. Press the Power button. All the LCD symbols will appear. Then
the cuff will begin to inflate automatically.
Note:
When the device is connected to your mobile device (via
Bluetooth),you can also initiate the measurement by tapping
(h)
. The cuff will begin inflate automatically.
2. The heart symbol " " will flash when a pulse is detected
during the inflation. (l) After the measurement, the monitor
displays the systolic pressure, diastolic pressure and pulse
rate. (m)
3. Press the Power button to turn the device off.
Note:
If the device is left idle for 3 minutes, it will turn off automatically.
" . If the problem still persists,
B. Average Measurement (via APP)
Automatically performs three (3) consecutive blood pressure
measurements and displays the average result in the end.
This function is only available when your Diamond CUFF BP is
connected to your mobile device.
1. Press the Bluetooth button. The "
the display, indicating that the device is ready to transmit
data. (n)
Important!
Be sure the device is properly connected to your mobile
device via Bluetooth. (o)
2. Launch iFORA BP app. The main screen appears on the
mobile device's screen.
3. Set Average Mode to ON and tap
the cuff will begin to inflate automatically.
4. After the first measurement is complete, the device and
iFORA BP app will start counting down before the second
measurement begins. The device will take three (3)
measurements consecutively with an interval of 20 seconds.
Note:
When the difference between the first and second systolic
pressure is more than 15mmHg, the time interval for third
measurement will be 40 seconds.
5. After taken three measurements, the test result is displayed
on the screen. Press the Power button to turn the device off.
EN-4
Diamond CUFF BP Owner's Manual
" icon will appear on
. (p) Then